FREE shipping when you spend $119 or more!

SAN-AIR is designed to combat airborne mould, bacteria and viruses, naturally. To make it easy to understand how to use and install our innovative products, you’ll find detailed, step-by-step instructions below. Our videos are created to ensure you can maximise the effectiveness of SAN-AIR products safely and efficiently.  

Split System SAN-AIR Pack

Installation instructions:
  1. Open the Cover: Carefully open the cover of your split system heat pump / air conditioning unit.
  2. Prepare the Gel Pack: Locate the small nipple at the side of the gel pack. Using scissors, cut across the nipple to open the pack. Important: Do not peel off the gel pack cover.
  3. Position the Gel Pack: Place the gel pack near the coil, behind the filter.
  4. Close the Cover: Securely close the cover of your split system unit.

That’s it! Every time your air conditioner is on, SAN-AIR Bio Clean Gel will start working immediately to eliminate 99% of mould, bacteria, and viruses within the system, while also cleaning incoming and outgoing air streams.

For a step-by-step visual guide, please see our installation video.

SAN-AIR Pottle

Installation instructions:
  1. Remove Lid: Carefully unscrew and remove the lid from the gel pottle.
  2. Peel Film: Gently peel off the protective film to expose the gel.
  3. Return Lid: Replace the lid securely on the pottle.
  4. Open Vents: Open the required number of vents based on your room size (up to 20 squares per open vent).
  5. Position Pottle: Place the gel pottle on any flat surface in your desired location, ensuring there is some airflow.
  6. Enhance Airflow: If the location has minimal airflow, use the gel pottle with our air diffuser. The gel requires air to flow over it to evaporate and spread its vapors throughout the air space.
For optimal results, make sure the gel pottle is situated where it can benefit from the natural or mechanical airflow within your indoor space.

SAN-AIR Diffuser Installation

To ensure optimal performance of our gel pottles in low airflow environments, it is best used with our air diffusers.

Installation instructions:

  1. Remove Lid: Take off the lid of the gel pottle.
  2. Peel Film: Carefully peel off the protective film from the gel pottle.
  3. Return Lid: Place the lid back on the gel pottle.
  4. Open Vents: Open the required number of vents based on your room size (up to 20 squares per open vent)
  5. Insert Batteries: Insert the required batteries into the air diffuser.
  6. Choose Frequency: Select the frequency setting: 24-hour, day, or night operation.
  7. Choose Interval: Choose the interval setting: 1 minute on / 1 minute off, 1 minute on / 3 minutes off, 1 minute on / 5 minutes off.
  8. Place Pottle Inside Diffuser: Insert the gel pottle into the air diffuser.
  9. Close Diffuser: Close the air diffuser.
  10. Place on Surface: Position the air diffuser on a stable surface in the desired location.

By following these instructions, you’ll help ensure that the gel evaporates and spreads effectively throughout the airspace in areas that have little to no airflow.